Hỗ trợ trực tuyến

Hỗ trợ kỹ thuât

(+84-4)38771700
  • Sản phẩm bán chạy
  • Panasonic Product

  • Hakko Products

  • SMC Product

  • Schleuniger Products

  • RKC Product

  • adpack products

  • kyowa product

  • t-h-m product

  • Rgl product

  • OTSUKA products

  • OSAWA productS

  • ANEST

  • Other Product


Thông tin: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

HAKKO FT-710

Giá: Liên hệ
dsada
Tip cleaner having both wire-type and sponge-type advantages
alt Prevents solder from splashing when cleaning.
  · Inserting just the tip into the receptacle completely prevents solder from splashing.
  Inserting the iron here blocks the receptacle and prevents solder from splashing. alt
alt Two-types of brushes control how much solder is removed.
  · Solder removal status can be adjusted by plastic brushes and metallic brushes.
  With wire-type cleaners, excessive amounts of solder remain on the tip, which causes solder to splash when soldering. With sponge-type cleaners, oxidation is promoted, which causes shorter tip life.
· A tip cleaner with both wire-type and sponge-type advantages eliminates the above problems when soldering.

 

Comparison of how much solder is removed by the different cleaning methods<
  * The photos show the iron tips T12-D24.
   Comparison of how much solder is removed by the different cleaning methods
Enlarged images of cleaning brushes

 

alt Minimizes decrease in temperature of the tip while cleaning.
  · Inserting the tip turns the brush automatically; no need to switch it on and off.
· Reduces the tip cleaning time between soldering works to increase work efficiency.
· The electric rotary cleaner provides a uniform final cleaning status with no differences between individuals.

 

Comparison of decrease in tip temperature by cleaning method
  If decrease in temperature is small, the time for a single cleaning also becomes short. Because cleaning is performed many times per day, the overall working time can be also shortened.
  Time for single cleaning (The time for a single cleaning is measured as the time until the tip temperature reaches the set temperature after cleaning.)
 
HAKKO FT-710 Approx. 2.3 sec. (reference value)
Wire-type HAKKO 599B Approx. 2.9 sec. (reference value)
Cleaning sponge Approx. 6.0 sec. (reference value)
Comparison of decrease in tip temperature by cleaning method

 

alt The low-noise design relieves stress due to noise during work.
  * This cleaner is very quiet in comparison with competitor's electric tip cleaner.
alt Easy to maintain Easy to maintain
  · Easy-to-replace brushes
  → Brushes can be replaced without removing any screws.
  · Solder left inside is stored in "Solder waste collector".
  → Solder does not splash all over the inside of the main body.
  · Safe design prevents brushes from turning unexpectedly during replacement.
  → The brush cannot be replaced unless the AC adapter is unplugged.
   
alt This tip cleaner can be attached to HAKKO iron holders HAKKO FH-101, FH-200 and FH-201.
  · This tip cleaner can be attached to any of the above 3 iron holders using just 2 screws. For other iron holders, this tip cleaner can be placed next to the iron holder.
Example when attached to the HAKKO FH-200,Example when using with the HAKKO FH-800 * The HAKKO FT-710 itself cannot be used as an iron holder. Be sure to use it together with an iron holder.
Last Updated: Thứ bảy, 18 Tháng mười một 2017 02:11