Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.
Tip cleaner having both wire-type and sponge-type advantages | |
![]() |
Prevents solder from splashing when cleaning. |
· Inserting just the tip into the receptacle completely prevents solder from splashing. | |
![]() ![]() |
|
![]() |
Two-types of brushes control how much solder is removed. |
· Solder removal status can be adjusted by plastic brushes and metallic brushes. | |
With wire-type cleaners, excessive amounts of solder remain on the tip, which causes solder to splash when soldering. With sponge-type cleaners, oxidation is promoted, which causes shorter tip life. · A tip cleaner with both wire-type and sponge-type advantages eliminates the above problems when soldering. |
Comparison of how much solder is removed by the different cleaning methods< | |||
* The photos show the iron tips T12-D24. | |||
![]() Enlarged images of cleaning brushes |
![]() |
Minimizes decrease in temperature of the tip while cleaning. | |
· Inserting the tip turns the brush automatically; no need to switch it on and off. · Reduces the tip cleaning time between soldering works to increase work efficiency. · The electric rotary cleaner provides a uniform final cleaning status with no differences between individuals. |
Comparison of decrease in tip temperature by cleaning method | |||||||||
If decrease in temperature is small, the time for a single cleaning also becomes short. Because cleaning is performed many times per day, the overall working time can be also shortened. | |||||||||
Time for single cleaning (The time for a single cleaning is measured as the time until the tip temperature reaches the set temperature after cleaning.) | |||||||||
![]() |
![]() |
The low-noise design relieves stress due to noise during work. | |
* This cleaner is very quiet in comparison with competitor's electric tip cleaner. | ||
![]() |
Easy to maintain | ![]() |
· Easy-to-replace brushes | ||
→ Brushes can be replaced without removing any screws. | ||
· Solder left inside is stored in "Solder waste collector". | ||
→ Solder does not splash all over the inside of the main body. | ||
· Safe design prevents brushes from turning unexpectedly during replacement. | ||
→ The brush cannot be replaced unless the AC adapter is unplugged. | ||
![]() |
This tip cleaner can be attached to HAKKO iron holders HAKKO FH-101, FH-200 and FH-201. | |
· This tip cleaner can be attached to any of the above 3 iron holders using just 2 screws. For other iron holders, this tip cleaner can be placed next to the iron holder. |
![]() |
* The HAKKO FT-710 itself cannot be used as an iron holder. Be sure to use it together with an iron holder. |